Page Comparison

...

The Split Drawing mode Mode allows floors Floors & ceilingsCeilings, walls Walls & openings Openings to be easily split Split into additional copies. Enter the split drawing mode Enter Split Drawing Mode by clicking the Split button on the left toolbar or using the keyboard shortcut '⌨ T". 

Splitting Openings

To Split an Opening hover over the Opening you would like to split Split and 🖱 click at the desired location. The cursor 🖱 Cursor will snap Snap to some standard fractions such as 1/3 & 1/2 to allow more accurate Splits. You can also type in the desired width and hit enter to split Split at specific widths.

Splitting Walls

Walls can be similarly split by hovering over the target wall Wall and left🖱 Left-clicking.

Splitting Floors & Ceilings

Split Drawing mode Mode has 3 submodes Sub-Modes that  are only of relevance when splitting floors Floors or ceilings Ceilings. They are:

1. Split both Floors & Ceilings,

2. Split Floors only, and

3. Split Ceilings only.

...

Toggle through the submodes Sub-Modes by pressing the submode Sub-Mode button in the guide-box or using the '⌨ Tilde " ` keyboard shortcut.

Floors & Ceilings can be split Split either Edge-to-Edge or internally Internally.

To split Split from edge Edge-to edge-Edge, hover the mouse 🖱 cursor near an internal edge of a floor Floor or ceiling Ceiling until the edge is highlighted.

🖱 Click the desired starting point of the split Split and then draw the split Split line continuously until you reach another edge of the floor Floor or ceilingCeiling.

🖱 Right-click Click to remove previous points and hold shift ⌨ Shift to draw straight lines as in other drawing modesDrawing Modes.

You can currently only split Split one floor Floor or ceiling Ceiling at a time, so the split Split shape must remain within a single floorFloor/ceiling Ceiling to complete, otherwise you will prompted with an Error message in the status barStatus Bar.

To split Split a polygon internally, the first point clicked must be away from a floor Floor or ceiling Ceiling edge. Trace the split Split shape as for edge-splits and double🖱 Double Left-click Click to finish completing the shape or click 🖱 Click back at the origin Origin to complete the splitSplit.

...

MERGE

You can also perform a Merge of walls Walls, floors Floors & ceiling Ceiling which combines objects back into a single object. Mergeable objects currently include Walls, Floors & Ceilings.

To perform a Merge, you must prePre-select Select the objects you would like to merge. Mergeable objects currently include walls, floors & ceilings.

...

Select two or more mergeable objects Mergeable Objects and hit the Merge button on the left toolbar Left Toolbar or the "⌨ M" keyboard shortcut.

If you do not select mergeable objectsMergeable Objects, for example floors Floors that do not share points, an error Error message will be shown in the status bar.